Medium Power 144 MHz Amplifier using the Y799 tube.

One amplifier, based on the Eimac Y799 tube (conduction cooled version of the 4CX250B) is under construction. This will be used to drive the YC156/3CX5000A7 amplifier, also under construction. The amp should be able to use a Y808 too. I don't have a Y808 data sheet, but am told its very similar to the Y799. If anyone has a Y808 data sheet, please let me know by email This Y799 (or Y808) amplifier should produce about 250 to 300 W in class AB1 at reasonable intermodulation performance. The amplifier has a large (0.2 deg C/Watt, weighing 15 kg) heatsink, and should keep the tube below the maximum 250°C at 200 W dissipation. 200 W dissipation should be sufficient for about 250 W of output, which should be adequate to drive the YC156 or 3CX5000A7

The screen and grid supply will use the G3SEK tetrode boards. The heater supply will be regulated with a 5A 3-terminal regulator.

Picture of a Y-808 tubePicture of a Y808Picture of a 3rd Y808 The Y799, is similar to the Y808 I believe. Any hard data on either tube would be appreciated.
Top view of Y-799 Amplifier This shows the top view of the amplifier (click on the image for a higher resolution version). The output will be coupled from the line inductively - note the variable loading capacitor on the left of the anode region. 
Close-up of anode region of amplifier Here is a close up of the anode of the tube. Note the square anode of the Y799 tube. The heat sink adapter has a gold coloured block mounted mounted on the tube with thermally conducting  paste and a while BeO link to conduct heat to the heatsink which will be attached to the rear. Note the anode line and tuning capacitor. The anode tuning control consists of a disk attached to shaft, which has an M6 thread on it. This moves back and forth as the shaft is rotated. A locking nut, which is not installed, will be used to stop the tuning control shorting out the HT supply. A small microswitch will be held closed normally by something soldered  to the anode with a low melting point solder. Should the anode get too hot, the link will melt and shut the amplifier down. 
Side view of amplifier In the side view, we can see the there are is a compartment below the tube where the input section of the tube is located. 
Bottom view of amplifier - grid area He we can see the Eimac SK-660A base, which is made from white BeO to conduct heat away from the tube. The grid tuning capacitor can also be seen. 
rectifier stack and HV fuses The high voltage rectifier stack consists of 10 P600M 1000V, 6 A rectifier diodes in series. There are two fuses in series on the AC input to the rectifiers, as I'm not quite sure what fuses to use. On the DC output will be a 500 mA high-voltage fuse, made by Bussman. The PTFE sheet shown is to insulate this from other components in the amplifier.


I'd like to express my thanks to Megagate who are providing free hosting for this site.

Valid HTML 4.01 Valid CSS! Thank you to MegaGate for hosting g8wrb.org